Abus FU8006 Secvest 2WAY Wireless Alarm Control Panel ( Instrukcja Użytkownika Pobierz pdf (Strona 19)

The alarm centre registers the status of your commands through different

tones:

Beep = Command accepted

Beep, beep = Action carried out

Bup = Action failed

Eeh, oh (three times) = Alarm

Pip, pip, pip, pip, pip = Reset required

x You can now listen to the “Voice prompts” of the alarm centre on the

phone.

x The “Voice prompts” with special key combinations (see also chapter

on “Remote control

by telephone”) are as follows:

o #0*0 = Deactivate system

 “The alarm system is deactivated”

 In the event of an alarm, also: “Reset is required”.

(Enter the following key combination “#1*1”.)

o #0*1 = Activate system

 “The alarm system is activated”

Note:

The alarm system is activated, even if zones of the

type “Normal Alarm” and “Exit Norm.Alm” are still

open. These zones are omitted.

You have forgotten to set your alarm system

at home. This behaviour allows you to set

your alarm remotely, even if some interior

doors are open.

For controlling with the Realtime Monitor of

the downloader, the same behaviour occurs.

o #0*2 = Activate internal system

 “The alarm system is activated internally”

 Note:

The alarm system is activated internally, even if none

of the zones has the “Attribute” “Part setting – yes” or

if zones of the type “Normal Alarm” and “Exit

Norm.Alm” are still open. All these zones are omitted.

Refer to the note above as well.

o #1*0 = Disable sirens

 In the event of an alarm: “An alarm has been

triggered”

o #1*1 = Reset system

 In the event of an activated system: “The alarm

system is activated”

 In the event of a deactivated system: “The alarm

system is deactivated”

 In the event of an internally activated system: “The

alarm system is activated internally”

 After an alarm (key combination #0*0 is pressed

beforehand): “The alarm system is deactivated”

o #3* = Query system

 In the event of an activated system: “The alarm

system is activated”

 In the event of a deactivated system: “The alarm

system is deactivated”

 In the event of an internally activated system: “The

alarm system is activated internally”



In the event of an alarm: “An alarm has been

triggered”

Note

In the event of an alarm, first press the “#0*0” key combination for “Deactivate

system” and then the “#1*1” key combination for “Reset system”.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 46 47

Komentarze do niniejszej Instrukcji

Brak uwag

Abus FU8006 Secvest 2WAY Wireless Alarm Control Panel ( Instrukcja Użytkownika Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Dla domu Abus FU8006 Secvest 2WAY Wireless Alarm Control Panel (