Abus FU9001 Dokumentacja Pobierz pdf (Strona 41)

100

101

7-41

Zone Type

When a detector triggers, it always sends a signal to the alarm system. For

example: A motion sensor reacts to movement, a smoke detector to smoke, etc. So

it is important to tell the system HOW and WHEN it is to react to a signal from a

detector.

Under Zone type, you can program the behaviour of the alarm system when it

receives a signal from a detector. It is absolutely necessary to program this

behaviour since your alarm system will not work without it. The following zone

types are monitored, depending on the state of the alarm system:

1. Disarm: The system reacts to the following zones only: 24-hour, fire, panic and

fault.

2. Arm: The system reacts to all zones.

3. Stay (Internal arm): The system does not react to zones you have programmed

as internal zones. This setting enables you to move within the object when the

perimeter is protected.

There are 22 zone types, whose properties are described in the following:

Under Parameters, press

to get to the Zone type menu option. You see the

following on the display:

Enter a two-digit zone number and press

Select and configure the zone types as follows:

Zone Type

Quick-Key Menu option Default Selection

ZZZZ

0000

Not used

NONE

zone programmes as not used is not monitored. The alarm system reacts neither to

battery faults, tampering, nor monitoring failure of the detector trained for this zone.

However, a trained detector is not deleted.

ZZZZ

0101

Exit/Entry 1

rmed/internal

zone programmed as Exit/Entry 1 must not be opened during the exit delay time without

an alarm being triggered. However, the zone must be closed before the exit delay time

expires. If the zone is opened when the alarm system is active, the entry delay time of

Group 1 (to be programmed under System/Timers) is started. The area of the wireless

alarm system must be deactivated in this time. If not, an alarm is triggered following the

expiry of the delay period. Detectors trained for a zone with this property are usually fitted to

front and side doors. This zone must be closed at the moment of activation. If this cannot

always be guaranteed, choose the zone type Exit(OP)/Entry

ZZZZ

0202

Exit/Entry 2

rmed/internal

See above. However, for zones of this type, the times of Group 2 apply.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 100 101

Komentarze do niniejszej Instrukcji

Brak uwag

Abus FU9001 Dokumentacja Strona 41

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Abus FU9001